Before the driver can be used the National Instruments software must be installed and the interface must be correctly configured in the NI software. GPIBNI The GPIBNI Driver supports NI and compatible GPIB cards. GPIB900 The GPIB900 driver only supports the TransEra GPIB Interfaces Model 900. There are a number of parameters and configuration options which are controlled through the SICL Interface. Before the driver can be used, the Agilent I/O Libraries must be installed and the interface must be correctly configured for SICL. HPIBS The HPIBS Driver supports HP/Agilent and compatible GPIB cards.
What driver should I use for my GPIB Interface? So you could also use ISC 20 (if available): LOAD BIN 'GPIOS DEV gpio12 ISC 20' 6. Write down the Device Name.įor example, if you have installed a GPIO interface with the device gpio12, add the following line to your AUTOST file: LOAD BIN 'GPIOS DEV gpio12 ISC 12' Now you can immediately output data to your GPIO interface: OUTPUT 12 Data You can customize the ISC (Interface Select Code), only make sure that there is no conflict with any exsiting ISC. Then install the driver software for your GPIO interface, after that shut down the computer and install the GPIO hardware. How do I load the driver for a GPIB PCMCIA interface? Install the Agilent I/O Libraries. Change the SICL Device Name if needed: lan:lan0 If all settings are correct, load the driver using the 'Load' button. Just add a new 'HPIBS' driver and open the properties page. The driver for the LAN/GPIB controller can also be laoded through Device Setup. Adjust this setting according to your configuration. After the interface has been configured use the following command in HTBasic: LOAD BIN 'HPIBS DEV lan:lan0 ISC 7' lan0 is the device name. Make sure that the controller has been configured correctly within the SICL software (Agilent Connection Expert).
This documents outlines the most current drivers available for most GPIB hardware when used with Microsoft Windows and DOS.
0 kommentar(er)
